Squeeze Film Flow With Nonlinear Boundary Slip
-
摘要: 用一种包含初始滑移长度和临界剪切率的非线性边界滑移模型研究了两个球体间的挤压流体膜问题.研究发现初始滑移长度对低剪切率下的滑移行为起主要作用,而临界剪切率决定了高剪切率下的边界滑移程度.球体表面挤压流体膜的边界滑移量是与半径坐标相关的高度非线性函数.在挤压膜的中心点和远离中心点处由于低剪切率滑移量等于初始滑移长度,然而在高剪切率区域滑移长度迅速增加.球体挤压膜的流体动压力随着初始滑移长度的增加和临界剪切率的减小而减小,并且临界剪切率对流体动力的影响要比初始滑移长度大的多,当临界剪切率很小的情况下,流体动压随着最小膜厚的减小几乎不再增加.所用模型给出的理论预报和实验非常吻合.Abstract: A nonlinear boundary slip model consisting of an initial slip length and a critical shear rate was used to study the nonlinear boundary slip of squeeze fluid film confined between two approaching spheres. It is found that the initial slip length controls the slip behavior at small shear rate, but the critical shear rate controls the boundary slip at high shear rate. The boundary slip at the squeeze fluid film of spherical surfaces is a strongly nonlinear function of the radius coordinate. At the center or far from the center of the squeeze film, the slip length equals the initial slip length due to the small shear rate. However, in the high shear rate regime the slip length increases very much. The hydrodynamic force of the spherical squeeze film decreases with increasing the initial slip length and decreasing the critical shear rate. The effect of initial slip length on the hydrodynamic force seems less than that of the critical shear rate. When the critical shear rate is very small the hydrodynamic force increases very slowly with a decrease in the minimum film thickness. The theoretical predictions agree well with the experiment measurements.
-
Key words:
- boundary slip /
- nonlinear /
- squeeze film /
- fluid flow
-
[1] Lamb H.Hydrodynamics[M].New York:Dove,1932. [2] Faber T.Fluid Dynamics for Physicists[M].Cambridge:Cambridge University Press,1995. [3] Schnell E.Slippage of water over nonwettable surfaces[J].J Appl Phys,1956,27(10):1149—1152. doi: 10.1063/1.1722220 [4] Pit R,Hervet H,Leger L.Friction and slip of a simple liquid at solid surface[J].Tribol Lett,1999,7(2/3):147—152. doi: 10.1023/A:1019161101812 [5] Pit R,Hervet H,Leger L.Direct experimental evidence of slip in hexadecane:solid interfaces[J].Phys Rev Lett,2000,85(5):980—983. doi: 10.1103/PhysRevLett.85.980 [6] Bonaccurso E, Kappl M,Butt H J.Hydrodynamic force measurements: boundary slip of hydrophilic surfaces and electrokinetic effects[J].Phys Rev Lett,2002,88(7):076103. doi: 10.1103/PhysRevLett.88.076103 [7] Craig V S J,Neto C,Williams D R M.Shear-dependent boundary slip in an aqueous Newtonian liquid[J].Phys Rev Lett,2001,87(5):054504. doi: 10.1103/PhysRevLett.87.054504 [8] Bonaccurso E,Butt H J, Craig V S J. Surface roughness and hydrodynamic boundary slip of a Newtonian fluid in a completely wetting system[J].Phys Rev Lett,2002,90(14):144501. [9] Zhu Y,Granick S.Rate-dependent slip of Newtonian liquid at smooth surfaces[J].Phys Rev Lett,2001,87(9):096105. doi: 10.1103/PhysRevLett.87.096105 [10] Zhu Y, Granick S. Limits of the hydrodynamic no-slip boundary condition[J].Phys Rev Lett,2002,88(10):106102. doi: 10.1103/PhysRevLett.88.106102 [11] Hervet H, Leger L.Flow with slip at the wall: from simple to complex liquids[J].L C R Physique,2003,4(2):241—249. doi: 10.1016/S1631-0705(03)00047-1 [12] Sun M,Edner C.Molecular dynamics study of flow at a fluid-wall interface [J].Phys Rev Lett,1992,69(24):3491—3494. doi: 10.1103/PhysRevLett.69.3491 [13] Thompson P A,Troian S M.A general boundary condition for liquid flow at solid surfaces[J].Nature,1997,389(6649):360—362. doi: 10.1038/38686 [14] Maxwell J C.On stresses in rarified gases arising from inequalities of temperature[J].Philos Trans Roy Soc London,1879,170(3):231—256. doi: 10.1098/rstl.1879.0067 [15] White F M.Viscous Fluid Flow[M].New York:McGraw-Hill Book Company,1974. [16] Bair S, Winer W O.Shear strength measurements of lubricants at high pressure[J].ASME J Lub Tech,1979,101(3):251—256. doi: 10.1115/1.3453339 [17] Bair S, Winer W O.The shear stress rheology of liquid lubricants at pressure of 2 to 200 Mpa[J].ASME J Tribology,1990,112(2):246—252. doi: 10.1115/1.2920248 [18] WU Cheng-wei,ZHONG Wan-xie,Qian L X,et al.Parametric variational principle for viscoplastic lubrication model[J].ASME J Tribology,1992,113(4):731—735. [19] Stahl J,Jacobson B O.A lubricant model considering wall-slip in EHL line contacts[J].ASME J Tribology,2003,125(3):523—532. doi: 10.1115/1.1537750 [20] Priezjev N V,Troian S M.Molecular origin and dynamic behavior of slip in sheared polymer films[J].Phys Rev Lett,2004,92(1):018302. doi: 10.1103/PhysRevLett.92.018302 [21] Vinogradova O I.Drainage of a thin liquid film confined between hydrophobic surfaces[J].Langmuir,1995,11(6):2213—2220. doi: 10.1021/la00006a059 [22] WU Cheng-Wei,MA Guo-jun. On the boundary slip of fluid flow[J].Science in China,Series G,2005,48(2):178—187. doi: 10.1360/03yw0304
点击查看大图
计量
- 文章访问数: 1989
- HTML全文浏览量: 70
- PDF下载量: 623
- 被引次数: 0